Our 2010-2013 Camaro sequential 3rd brake light is sold as a direct swap circuit board. Simply remove your existing 3rd brake light circuit board from the vehicle's assembly, install ours in it's place, plug it in and you're set! It's plug-n-play!
This item is only compatible with the 2010-2013 COUPE Camaro.
It is NOT compatible with the 2010-2013 CONVERTIBLE Camaro.
Unit ships pre-programmed with two patterns of your choice, BRAKE and SHOW.
BRAKE = this pattern is activated upon hitting the brakes. This pattern will run for less than 3 seconds and then ALL the LEDs will come on solid until you let off the brake.
SHOW = this pattern is activated when the yellow "SHOW" wire on the back of the light is connected to any 12V+ source, this can be done using our Show Mode Easy Install Kit (sold separately), a switch at your dash or a switch in your trunk (switch and wire sold separately). Connection must be a 12V POSITIVE source. If the SHOW mode is on, and you hit the brake, the BRAKE pattern will always override the SHOW pattern for as long as the brake is held down. The show pattern will resume once the brake is released (if the SHOW was running). The BRAKE pattern is a 3 second sequence, the SHOW pattern is a continuous sequence.
Choose from the pattern list above.
Have a CUSTOM pattern idea? Please reach out to us and we will work with you on creating your custom pattern(s) at no additional charge!
We also offer FREE LIFETIME REPROGRAMMING! Simply pay for shipping both ways and we will change your patterns at no charge!